After install the network is not working correcly. I selected obtain IP automatically via DHCP however ifconfig only shows local loopback. The /etc/config file for eth0 look O.K, that is set to DHCP however no comms. ifup and ifdown commands are not on the box.
I have installed mini box workstation.
Any assistance be apperciated.
Activity light is flashing on the hardware to suggest comms phyiscal link is there.
Not to hijack this thread, I think it is the same problem I am having. When I try "ifconfig eth0 192.168.xx.xx up", I get an unknown interface error message.
Any ideas?
lspci -v
00:0e.0 Ethernet controller: VIA Technologies, Inc. VT6120/VT6121/VT6122 Gigabit Ethernet Adapter (rev 11)
Subsystem: VIA Technologies, Inc. Unknown device 0110
Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 11
I/O ports at f800 [size=256]
Memory at fdffe000 (32-bit, non-prefetchable) [size=256]
Capabilities: [50] Power Management version 2
relevant dmesg
via-rhine.c:v1.10-LK1.2.0-2.6 June-10-2004 Written by Donald Becker
Sorry I had to type this, so if you need more of the dmesg output, I could get it later. Having issues hooking up a usb drive to this.
Other relevant info
OS: Imedia Linux version 4.01
Motherboard: Epia EN15000g
Memory: 1gig Corsair
Tue, 2007-03-20 21:29 
Joined: 2007-03-20
Hi All,
After install the network is not working correcly. I selected obtain IP automatically via DHCP however ifconfig only shows local loopback. The /etc/config file for eth0 look O.K, that is set to DHCP however no comms. ifup and ifdown commands are not on the box.
I have installed mini box workstation.
Any assistance be apperciated.
Activity light is flashing on the hardware to suggest comms phyiscal link is there.
Cheers all,